Instructions

Locate a sunny place to hang the GrowMesh™ Mini
Mix 1 GrowMesh nutrient packet with 1 gallon of water and add the reservoir's nutrient solution.
Plugin the GrowMesh Mini system. There is not an on/off switch. It will run continuously when plugged in.
Add a seed to the hole in the center of the plug. Push plug with seed into a pocket, small side down seed side up.
Top off the reservoir with nutrient solution regularly. Completely change reservoir solution every month.
Harvest food in as little as 5 weeks.

Plants need Sun – Water- Nutrients – to grow well.

Placing GrowMesh™ in a sunny location is a must!
Keep the solution topped off and Change the solution every month.
As the plant and root system grow, it may be necessary to pull apart the sides of the GrowMesh™ sleeve, providing the roots more room.
If you notice a plant wilting, use a finger to check for water in the pocket. If no water is felt, gently push the mesh in the back of the pocket to open the channels.
If you notice a pocket leaking, use a finger to gently push on the mesh in the back of the pocket to open additional channels for the water to drain.
When hanging the GrowMesh Mini, the use of a strong stand or hook is necessary. Secure the stand or hook from falling over in case of wind.
If necessary, you can hang against a wall, only planting one side. Follow the same feeding instructions as if all pockets were planted.
The Main sleeve is designed for one growth cycle; this eliminates cleaning and the eventual damage by UV light. The GrowMesh™ Sleeve is made from HPDE 2 for recycling.
The pump and reservoir are for multiple uses.

!Cautions and Warning!

Keep Plant nutrient packets out of the reach of children! The packets contain concentrated fertilizer.

GrowMesh™ Mini is designed not to leak however, water leaks are possible!